Browse all practice questions for the Private Applicator Agricultural Pest Control Practice Test. Search by topic, open any question and review its full explanation, then test yourself in the practice quiz.

Private Applicator Agricultural Pest Control Practice Test course image
More practice questions

These questions are part of the practice quiz. Start practicing

  • Which pest management method involves releasing more natural enemies into the field to boost pest suppression?
  • Fungicides target which major pest group?
  • Which of the following is a reason why a pesticide may fail to control a target pest?
  • Which pest management method can involve exploiting the soil's natural microbial antagonists to suppress pests?
  • How many pints are in 23.75 gallons?
  • What is the numerical factor that converts bed-applied per-acre rates to broadcast rates given bed width 40 inches and row spacing 72 inches?
  • What is the best way to minimize potential problems with pesticide storage?
  • Which statement best describes how the application exclusion zone length is determined?
  • Which of the following is not an effective method of sealing a fumigant into the soil?
  • What does the '20% rule' refer to when selecting a pump for pesticide applications?
  • What does nozzle code 8002 designate?
  • How many acres are being treated with a 980-foot center pivot with a 50-foot end gun?
  • Absorption is defined as fumigant molecules doing what?
  • Under the Worker Protection Standard, is training required for employees who only clean, repair, or adjust pesticide application equipment?
  • What is the primary reason pesticide resistance develops?
  • Strainers with higher mesh numbers filter out smaller particles.
  • Which of the following is not one of the pest management approaches described?
  • Which of the following is a reason for pesticide failure?
  • What is the inherent ability of a species to survive and reproduce after pesticide treatments?
  • Which best describes the optimal injection depth below the soil surface for most fumigant applications?
  • Which statement about biological control methods is true?
  • When is the best time to make pesticide applications so as to have minimal impacts on honey bees and other pollinators?
  • Which is considered a preventive pest management strategy?
  • What is the travel rate in feet per minute if 250 feet are covered in 28 minutes?
  • Which statement about pest management is most directly supported by accurate pest identification?
  • An invasive species is threatening a new area. What pest control approach should you use?
  • What is the purpose of an air gap or back-siphoning device in pesticide application systems?
  • Which statement is true regarding fumigation sealing, particularly with phosphine?
  • When must workers and handler employees receive WPS training?
  • If a 200-gallon tank is used to apply at 25 gal/acre, how many acres can be treated?
  • Who is in charge of mixing, loading, and applying pesticides?
  • Which term best describes a plant that completes its life cycle in one year?
  • If 95 acres are treated at 2.0 pints per acre, how many gallons of product are required in total?
  • Which statement about nematodes is false?
  • The category certification standards define the practical knowledge required for private applicator certification.
  • What is the minimum age required for a handler or worker to perform early-entry tasks under WPS?
  • If the tank height is doubled to 24 feet with the same diameter, the tank capacity would be approximately how many gallons?
  • Which statement best reflects the effect of sorption on fumigant performance?
  • Which of the following is a commonly cited neonicotinoid insecticide?
  • What type of life cycle do Johnsongrass and purple nutsedge have?
  • What is a major disadvantage of polypropylene and polyethylene materials for constructing pesticide tanks?
  • What does REI stand for in pesticide labeling?
  • Which safety requirements are mandatory when using methyl bromide?
  • What is the purpose of assigning a group number to a pesticide active ingredient?
  • What is 11 hours 43 minutes expressed in decimal hours, to two decimal places?
  • Which insect life stages are most effectively controlled by fumigants?
  • Drift can pose health risks to which groups?
  • Which of the following is NOT a required decontamination supply for workers who have been in an area under REI within the past 30 days?
  • Which pest management method involves altering the crop's environment to deter pests?
  • Which of the following is a reason why a pesticide may fail to control a target pest?
  • For how long is a private applicator license valid before renewal?
  • Which statement regarding sorption is false?
  • Name the category of weeds described as narrow, upright leaves with parallel veins; round stems.
  • Which pest management method uses barriers to keep pests from crops?
  • Which statement about IPM strategies is true?
  • What is the proper injection rate for a center pivot irrigation system that has a total rotation time of 20 hours and total volume of pesticide required is 28.4 gallons?
  • A private applicator is a person who applies
  • Which pest management strategy is emphasized in IPM as a core approach?
  • Which pest management method uses plowing to control weeds?
  • Which nozzle material best resists abrasion?
  • Under WPS, which action by an employer toward a compliant worker is prohibited?
  • Which factor should you consult to verify the exact REI for a product?
  • The manner in which a pesticide destroys or controls a pest is called?
  • Which unit is used to express the labeled rate in the bedded field calculation?
  • Which pest management method uses plant genetics to reduce pest damage?
  • What is the area of the base of the cylindrical tank in square feet?
  • Which conversion factor correctly converts gallons to milliliters?
  • What type of life cycle does cutleaf evening primrose have?
  • If equipment travels 792 feet in 3 minutes, what is the speed in mph?
  • Which statement best describes neonicotinoids as a class?
  • How can you determine the length of a product's restricted entry interval (REI)?
  • What is the product amount per acre in gallons when 23.75 gallons are required for 95 acres?
  • What is the speed in mph if the distance covered is 880 feet in 2 minutes?
  • If 10 ounces of granules are collected on a 150 square foot tarp during a trial run, how many pounds per acre are being applied?
  • Which pest management method involves redesigning a structure to make manure removal easier?
  • Which pest management method uses a chemical to control disease?
  • The cost of a 4 year license for private applicators is
  • What is the appropriate first step to take in cleaning up a pesticide spill?
  • Mammals, birds, reptiles, and fish are vertebrates because they have a jointed backbone. True or False?
  • On what life stage are insecticides usually most effective?
  • The declines in bee and pollinator populations in recent years are most likely due to which scenario?
  • Name the category of weeds described as wide leaves with netlike veins; seedlings have two leaves.
  • Which pest type is described as pests that become a problem due to the control of another pest?
  • What is the total capacity of a cylindrical chemical storage tank that has a height of 12 feet and a diameter of 6 feet?
  • Which of the following compounds is a commonly cited neonicotinoid insecticide?
  • Which type of pump is an excellent choice for a high volume, high pressure application?
  • Under WPS, the agricultural employer cannot intimidate, threaten, coerce, discriminate against, prevent, discourage, or fire any worker or handler from complying with the WPS.
  • Pest populations need to be reduced so natural enemies can take over. What pest control approach should you use?
  • Which of the following is a reason for pesticide failure related to the product's condition?
  • To meet federal and state law requirements, how much pesticide must be spilled to require reporting to authorities?
  • Which option is not part of the 20% rule when selecting a pump?
  • Which pest type causes problems only under specific circumstances or certain times?
  • Which combination accurately describes continuing education units required for private applicators?
  • What major pest group do herbicides target?
  • Name the category of weeds described as triangular stems; leaves in groups of three.
  • During and shortly after methyl bromide application, regulation using which method is often employed?
  • Which pest type describes a pest that becomes a problem as the result of the control of another pest?
  • Which factors determine the size of the application exclusion zone?
  • What is a legal requirement of chemigation systems?
  • Which pest management method involves rearing and releasing natural enemies?
  • For a 1.5% solution, how many ounces of product should be mixed with two gallons of water?
  • If the average distance from a micro-sprinkler emitter to the edge of the wetted area is 15 inches, how many acres in a 15-acre site are being treated if there are 250 emitters per acre?
  • Drift can lead to contamination of what in adjacent areas?
  • If warning signs are used to notify workers to stay out of a treated area, when should they be taken down or covered?
  • Which pest management method involves destroying diseased plant material?
  • The location to take restricted use pesticide certification exams is at
  • Drift may result in which legal consequence?
  • A center pivot irrigation system has a pivot to outer wheel track length of 1000 feet and it takes 28 minutes to travel a 250-foot staked course. What is the center pivot's rotation time for one complete revolution?
  • What does 'gpm' stand for in nozzle specifications?
  • If there are 250 emitters per acre and each wets a circular area of radius 15 inches, what fraction of an acre is wetted per acre?
  • Ants, beetles, caterpillars, and grasshoppers have __________ mouthparts.
  • What major pest group do insecticides target?
  • How many acres per minute are treated by a sprayer with a swath width of 60 feet traveling at 180 feet per minute?
  • Which label feature indicates a pesticide product falls under the Worker Protection Standard?
  • Which statement about pesticide labeling is true for determining safe re-entry or planting intervals after fumigation?
  • What is the gallons per acre when a sprayer outputs 0.62 gal/min and applies at 0.31 ac/min?
  • What is the method used to determine the presence or distribution of nematodes?
  • Which term best describes a plant that completes its life cycle in two growing seasons?
  • The practical knowledge that private applicators must demonstrate for certification is based upon the
  • For a 1.5% solution with 1 gallon of water, how many ounces of product are required?
  • Which soil texture would contain the most adsorptive sites and pore spaces per unit area?
  • Which of the following is a consequence of pesticide drift?
  • Which action demonstrates compliance with WPS concerning worker safety and retaliation?
  • Which pest management method uses rootstocks with the K84 strain of Agrobacterium radiobacter?
  • What is the optimal planting interval following a fumigant application?
  • What category of plant pathogens infects plants and is typically rod-shaped with flagella?
  • Calculate the number of row acres present in a site if crop spacing is four feet, there are 250 rows, and the average linear distance is 1,500 feet?
  • Which statement about sorption is true?
  • Which gas is most commonly used to propel fumigants?
  • Which pest type causes major damage on a regular basis?
  • What is the gallons per hour rate for 28.4 gallons over 20 hours?
  • Who is in charge of harvesting, pruning, and transplanting?
  • Which statement is false regarding the neonicotinoid class of insecticides?
  • Continuing education for private applicators includes core units and private units in what total?
  • Which of the following is a reason for pesticide failure related to pest adaptation?
  • With a 200-gallon tank applying 35 gal/acre, how many acres can be treated?
  • Which of the following could be a factor contributing to pesticide failure due to environmental conditions?
  • Adsorption is defined as fumigant molecules doing what?
  • If a cylindrical storage tank has height 12 feet and diameter 6 feet, what is the radius of the tank in feet?
  • In nozzle code 8002, what is the flow rate expressed in gallons per minute?
  • Name the category of plant pathogens: Identification usually depends on mycelium characteristics and fruiting bodies.
  • Which factors are required before a pathogenic disease can develop?
  • Which pest management method involves breeding plants for resistance to pests?
  • How long must records regarding respirator use be maintained by employers?
  • Convert the rotation time 11 hours 43 minutes into total minutes.
  • What type of life cycle do crabgrasses and pigweeds have?
  • Which statement describes the movement of neonics within plant tissue?
  • Which soil condition would most likely cause phytotoxicity problems following a fumigant application?
  • Name the category of plant pathogens: Very small organisms that multiply in living cells.
  • True or False: The use of system monitors and controllers do not completely eliminate the need for sprayer inspection and calibration.
  • True or False: Drift is the unintentional airborne movement of pesticides to nontarget areas.
  • Which pressure gauge statement is false?
  • What is the minimum soil temperature required for effective fumigant volatilization?
  • Pesticide drift can lead to the poisoning of which of the following?
  • What is the boiling point of methyl bromide that contributes to its rapid vaporization?
  • What is the key factor in delaying or preventing the onset of pesticide resistance?
  • Prior to using a respirator, what must the employer provide the handler with?
  • What is the approximate acres-per-minute for a sprayer with a 40-foot swath traveling at 120 feet per minute?
  • At labeled rate 1.5 pints/acre, to prepare a full 200-gallon tank applying 25 gal/acre, how much product is needed?
  • What is the acquired ability of a pest to survive and reproduce following exposure to a dose of pesticide normally lethal to the wild type?
  • Which of the following comprise the largest group of insects?
  • The exact location of inhibition is called?
  • Environmental conditions are favorable for disease development. What pest control approach should you use?
  • Which pest type causes problems only under certain circumstances or certain times?
  • Why is accurate pest identification so critical in managing a particular pest?
  • The number of continuing education units that a private applicator must obtain to keep the license valid
  • Which type of agitation system is the best for keeping wettable powder formulations evenly dispersed after mixing into the tank?
  • What is the broadcast equivalent rate for a shank-applied bedded field given bed width bottom 40 inches, row spacing 72 inches, product per treated acre in beds 100 lbs, and application block size 15 acres?
  • Which statement would best define suppression in pest management?
  • Which category of weeds is described as having narrow, upright leaves with parallel veins and round stems?
  • Which pest management method uses mesh cloth to exclude birds?
  • Which of the following statements is false regarding mites?
  • Which method is best to check for leaks in a fumigant application rig?
  • Florida law requires an air gap or back-siphoning device between the water supply and the application equipment to prevent backflow into the water supply.
  • Which type of metamorphosis do stink bugs and scales undergo?
  • Which category of weeds is described as having broad leaves with netlike venation?
  • Which document is required to be available for all products used?
  • Which term describes a plant that lives for more than two years?
  • Which of the following is false regarding plant disease?
Subscribe

Get the latest from Examzify

You can unsubscribe at any time. Read our privacy policy